* MV series power amplifier use particular THE MIRRORED FRONTED POWER SUPPLY BRIDGE to make the symmetrical circuit desing.
It can make more less distortion and better sound.
* With power auto swith system, power parallel connection in low power. in low power, increase the output current. And the
Voltage will auto increase in big power to increase the output power.
* It have input power supply filter, make the capability of anti-jamming more strong.
* Amplifier circuit with shield cover,add shield ring in transformer to make less noise, let the product have more clear sound.
* Independence close cooling wind path to make the cooling more fast, even use for long will be very clear.
* Have perect protect funtion,power on amortize,dealy connect speaker, limited funtion,over-current protect,over-heat protect,
Short-cut protect and output DC protect etc…
* Power supply voltage: AC220V/50Hz
* Output power(8Ω): 800W X 2
* Output power(4Ω): 1300W X 2
* Output power(2Ω): 1900W X 2
* Output power(bridge 8Ω): 2600W
* Output power(bridge 4Ω): 3800W
* Input impedance: 10KΩ balance to ground
* Frequency response @ half power: 15Hz-25kHz (±0/-1dB)
* THD+noise @ 1KHz full power: ˂0.035%
* IMD 60Hz & 7KHz,4:1 ˂0.04%
* Signal to noise ratio: ˃105 dB
* Damping factor: ˃400:1
* Slew ratio: 40V/μS
* Output circuit type: class H
* Output connectors: 4 pole speakon & binding posts
* Input sensitivity: selectable (0.77v/1.0v/1.44V)
* Input connectors: female XLR-3
* Protect: full short-circuit, open-circuit, thermal, soft-start, DC voltage, Sub/ultrasonic & RF
* LED indicators(per ch): power, signal, clip, protect
* Panel controls: FRONT-2 input attenuators, REAR lift, made selection, compressor
* Cooling: front to back via 2 variable speed fans
* Over current protection: 88-16A
* Net weight: 27 kg
* Gross weight: 29.50 Kg
* Dimensions( W x D x H)mm: 482 x 435 x 88.80